Water is collected from a channel and transported to next treatment. Along this path, all the particles of type that have a grainy sedimentation rate greater than the rate of climb of current are held in tub. In practice, the sedimentation depends on surface of tub and not by its volume (survival water purification systems). In fact the same flow rate of upward flow (Qa), the greater the surface (S) of tub, the lower the speed of upward flow (Va = Qa / S), the greater the proportion of particles sedimenting.
These sources of supply, due to specific characteristics of waters and / or the degree of pollution, must be subjected to cycles of treatments of filtration necessary to modify the characteristics and improve its quality. Often, this happens even for the deep waters with a high content of organic substances and a high microbial contamination, especially if they are present faecal bacteria (eg. Coliforms).
We can also make filters consist of two filter layers of materials with different specific weight (dual media). As a rule, in this case the top layer is made from anthracite, lighter, and the lower one is in quartz sand. The layer of asphalt, being formed by the coarser particles of sand, preserves the rapid occlusion of first layers of sand. After a certain time, the retained particles begin to clog the bed draining decreasing the permeability, and determining, at a constant flow rate of inflow, an increase in waters level in tanks filtering. Exceeded the limit level, the layer drained must be subjected to countercurrent washing to restore its efficiency.
Indeed, the presence of substances in suspension, for example, can nullify the effect of final disinfection since such particles may protect microorganisms against the action of disinfectants. In treatment of flocculation will exploit the properties of certain substances, called coagulants, which under certain operating conditions, in form of waters insoluble compounds with electric charge of opposite sign (positive charge) than that of colloids constituents as to eliminate the turbidity (negative charge).
Physical and chemical treatments normal and driven: they are divided into several phases and eliminate non-settleable suspended solids (flocculation) and correct the chemical characteristics of waters by eliminating the dissolved substances that are incompatible with the use to which the waters is bound (softening, stabilization, removal of iron, manganese, desilication, fluoridation and defluoration, aeration).
Filter volume: the filtration takes place by means of a three-dimensional porous matrix said filter bed consisting of discrete materials of small dimensions (eg. Sand); in this case the particles are retained within filter medium. The effectiveness of a filter material depends on certain properties of particles such as size, shape and surface chemistry. The filters lenses are the first filtration system used in filtration, but they are currently little used. The slow filtration can be used in case of turbidity 10 ppm.
The 'sodium aluminate is very expensive and is also used in treatment of lime-soda softening species in case of high hardness and magnesium. In some waters, even with a strong dose of coagulant, are unable to develop a staple of suitable density. Inse cases, adjuvants are added to waters coagulation to promote the densification of micro-flakes.
What lens filters the filtering action is exerted by the biological film that develops on the surface of filter in 10-15 days (aging time of filter). The film filter is very sensitive to mechanical disturbances and organic contaminants. During the period of maturation of film the filtered waters is not considered potable. The inflow of waters into filter takes place from above while runoff occurs from the bottom; the filtration rate.
These sources of supply, due to specific characteristics of waters and / or the degree of pollution, must be subjected to cycles of treatments of filtration necessary to modify the characteristics and improve its quality. Often, this happens even for the deep waters with a high content of organic substances and a high microbial contamination, especially if they are present faecal bacteria (eg. Coliforms).
We can also make filters consist of two filter layers of materials with different specific weight (dual media). As a rule, in this case the top layer is made from anthracite, lighter, and the lower one is in quartz sand. The layer of asphalt, being formed by the coarser particles of sand, preserves the rapid occlusion of first layers of sand. After a certain time, the retained particles begin to clog the bed draining decreasing the permeability, and determining, at a constant flow rate of inflow, an increase in waters level in tanks filtering. Exceeded the limit level, the layer drained must be subjected to countercurrent washing to restore its efficiency.
Indeed, the presence of substances in suspension, for example, can nullify the effect of final disinfection since such particles may protect microorganisms against the action of disinfectants. In treatment of flocculation will exploit the properties of certain substances, called coagulants, which under certain operating conditions, in form of waters insoluble compounds with electric charge of opposite sign (positive charge) than that of colloids constituents as to eliminate the turbidity (negative charge).
Physical and chemical treatments normal and driven: they are divided into several phases and eliminate non-settleable suspended solids (flocculation) and correct the chemical characteristics of waters by eliminating the dissolved substances that are incompatible with the use to which the waters is bound (softening, stabilization, removal of iron, manganese, desilication, fluoridation and defluoration, aeration).
Filter volume: the filtration takes place by means of a three-dimensional porous matrix said filter bed consisting of discrete materials of small dimensions (eg. Sand); in this case the particles are retained within filter medium. The effectiveness of a filter material depends on certain properties of particles such as size, shape and surface chemistry. The filters lenses are the first filtration system used in filtration, but they are currently little used. The slow filtration can be used in case of turbidity 10 ppm.
The 'sodium aluminate is very expensive and is also used in treatment of lime-soda softening species in case of high hardness and magnesium. In some waters, even with a strong dose of coagulant, are unable to develop a staple of suitable density. Inse cases, adjuvants are added to waters coagulation to promote the densification of micro-flakes.
What lens filters the filtering action is exerted by the biological film that develops on the surface of filter in 10-15 days (aging time of filter). The film filter is very sensitive to mechanical disturbances and organic contaminants. During the period of maturation of film the filtered waters is not considered potable. The inflow of waters into filter takes place from above while runoff occurs from the bottom; the filtration rate.
About the Author:
We can help you buy affordable survival water purification systems by introducing you to this valuable site. For additional information, log on to http://defpg.com today.
Aucun commentaire:
Enregistrer un commentaire